Tinker Board Forum

Full Version: how do I enable LIRC?
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
I have an IR sensor connected to the Tinker board.
It appears that lirc is not installed. I installed it using sudo apt-get install lirc

Im not sure that is or is not working properly. but I have no devices in /dev/lirc
to listen to. So i think this means it is not working.

how can I enable IR remote contol, and the devices of /dev/lirc ?

I have the sensor on GPIO pin 18, im not sure where to configure the GPIO for this driver.