This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
Tinker Board Forum › Tinker Board / Tinker Board S › Hardware v
Power supply for Raspberry PI touch screen

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Power supply for Raspberry PI touch screen
dead henry Offline
Junior Member
**
Posts: 25
Threads: 8
Likes Received: 1 in 1 posts
Likes Given: 1
Joined: Feb 2018
#1
03-02-2018, 08:00 AM
Aloha. I have just purchased the Raspberry PI 7 inch touch screen for my Tinkerboard. The YouTube videos suggest to power the unit by the usb-mini connector on the video board, then run jumpers from the video board to power the Tinkerboard via pins on the Tinkerboard's 40 pin connector. I would prefer to power each board separately. I want to power the video board through it's usb-mini connector and to power the Tinkerboard through it's usb-mini connector, each with it's own power supply. Is this acceptable? Mahalo.
Reply


Messages In This Thread
Power supply for Raspberry PI touch screen - by dead henry - 03-02-2018, 08:00 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)