This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
Tinker Board Forum › Tinker Board / Tinker Board S › Hardware v
Boot loop if not using a proper USB cable

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Boot loop if not using a proper USB cable
soundesigner Offline
Junior Member
**
Posts: 6
Threads: 2
Likes Received: 1 in 1 posts
Likes Given: 0
Joined: Jan 2019
#16
01-28-2019, 07:15 PM
This thread has been most illuminating! I'm running a 20 amp 5VDC supply and my Tinker Board will go into "boot loop", even with an 18 gauge power cord I made. I suspect the super-flimsy micro-USB connector I used is at fault, because a different cable works like a champ. I think it's time to go to the GPIO pins and be done. Thanks!
Honoring Major Edwin Howard Armstrong daily through the avid use of his inventions.
Reply


Messages In This Thread
RE: Boot loop if not using a proper USB cable - by soundesigner - 01-28-2019, 07:15 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)