This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
Tinker Board Forum › Tinker Edge R › Software
cv2.imshow() command doesn't work.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
cv2.imshow() command doesn't work.
ThomasNex Offline
ThomasNexAO
**
Posts: 5
Threads: 0
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Oct 2020
#3
11-28-2020, 06:46 AM
Hi guys
I am using ScenaristNT
When it starts , it gives me this message : "SigmaDesigns decoder card not installed"

But my realmagic hollywood plus is installed ok and works fine.

Help me please
tadalafil generic
Website
Reply


Messages In This Thread
- - by ThomasNex - 11-28-2020, 06:46 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)