Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tinker Board S - TinkerOS to SDcard kernel panic
#1
Photo 
Put latest TinkerOS 2.0.5 to SD card with Etcher.

Trying to boot:

VFS: unable to mount root fs on unknown-block(0,0)
Warning: CPU: 0 PID: 1 at kernel/watchdog.c:352 watchdogtimer_fn

Any clues?

i.imgur.com/gSwb3xJ.jpg
Reply
#2
(05-30-2018, 04:19 PM)roflmao Wrote: Put latest TinkerOS 2.0.5 to SD card with Etcher.

Trying to boot:

VFS: unable to mount root fs on unknown-block(0,0)
Warning: CPU: 0 PID: 1 at kernel/watchdog.c:352 watchdogtimer_fn

Any clues?

i.imgur.com/gSwb3xJ.jpg

Same goes for Diet PI. Armbian doesnt give any bootscreen.

Tinker Board S abit premature?
Reply
#3
It said unable to mount root fs.
I think that is the SD card issue...
Which SD card you use?
(SD card has lots of specs, and some quality...not enough...)

And have you changed the jumper?
I found this wiki page has been updated some info for Tinker Board S.
hope it can help you.
https://tinkerboarding.co.uk/wiki/index....ard_S_eMMC

// do you try eMMC too??
Reply
#4
(05-30-2018, 04:19 PM)roflmao Wrote: Put latest TinkerOS 2.0.5 to SD card with Etcher.

Trying to boot:

VFS: unable to mount root fs on unknown-block(0,0)
Warning: CPU: 0 PID: 1 at kernel/watchdog.c:352 watchdogtimer_fn

Any clues?

i.imgur.com/gSwb3xJ.jpg

Maybe you can check if the downloaded image file is complete first.
I have seen something like this and end up finding that I didn't download the whole image successfully Confused
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)