This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
gstreamer with camera doesn't work in 2.0.8
#1
Release 2.0.7 works fine using gstreamer and a cam connected to the MIPI interface. Installing version 2.0.8 and using the same camera generates an error. Trying it for a second time causes the device to hang, doesn't respond to anything.

Is this known? Otherwise I can provide output from gst-launch.
Reply
#2
CSI Camera is a little different between 2.0.7 and 2.0.8.
Please see below link:
https://tinkerboarding.co.uk/wiki/index.php/CSI-camera
Reply
#3
Thanks for the quick reply, missed that one. I will try with the new method.
Reply
#4
In V2.0.8, please use tinker-config to change camera form IMX219 to OV5647 if you use Raspberry Pi Camera Module V1 (OV5647).
Then reboot device.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)