This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Using the GPIOs under Hass.IO
#1
Hey guys, 
Good to be here Smile

I got a new tinker board S today to install and run my home assistant instance (hass.io)

Although everything went fine and very fast, i cant figure out how to use the GPIOs of the tinkerboard under hass.io.

Unfortunately i cannot find any information at the forums over there.

Is any buddy here running hass.io on tinker board and can perhaps help me out?

Thanks in advance, 

k.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)